Aruba Networks Access Point Aruba AP 60/61 Especificaciones descargar pdf (Pagina 80)

Spectralink VIEW Certified Configuration Guide: Aruba Networks

721-1002-000_AB.docx

March 2015 80

Logical and Physical Interfaces

This section defines the Layer-2/3 framework that connects the Spectralink phones with the

assigned Spectralink Gateway and SVP server through WLAN Mobility Controller (MC) and the

Access Points. The requirement is that the phones and Spectralink infrastructure be connected

over Layer-2 and have the L2 subnet span across L3 switching/routing fabric.

The steps involved are

1 Define a VLAN for voice on the WLAN.

2 Define the IP parameters for the VLAN.

3 Define the DHCP server for the phones to get their IP addresses.

4 Define the physical port assignment on the MC. Most deployments have the MC

uplinked to a Layer-3 switch which performs routing functions.

These parameters can be easily defined using the Controller Wizard on the WebUI.

Using CLI

IP Interfaces, VLAN configuration

(Aruba651) #configure terminal

(Aruba651) (config) #vlan <vlan ID>

(Aruba651) (config) #interface <vlan ID>

(Aruba651) (config-subif)#ip address <VLAN interface IP> <subnet mask>

(Aruba651) (config-subif)#ip helper-address <DHCP server / helper for the

VLAN>

(Aruba651) (config-subif)#write m

(Aruba651) (config-subif)#end

Physical Port Assignment

The uplink is configured as follows

(Aruba651) (config) #interface gigabitethernet <slot/port>

(Aruba651) (config-if)#trusted

(Aruba651) (config-if)#no shutdown

(Aruba651) (config-if)#switchport mode trunk

(Aruba651) (config-if)#switchport trunk allowed vlan <VLAN IDs>

(Aruba651) (config-if)#write memory

On the WebUI

1 Click the Configuration tab.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 122 123

Sin comentarios

Aruba Networks Access Point Aruba AP 60/61 Especificaciones Pagina 80